E 250 V8-5.4L SOHC VIN L (2004)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Rear, One-Piece
Driveshaft - Rear, One-Piece
Removal
1. Raise and support the vehicle.
2. To maintain driveline balance, index-mark the driveshaft flange yoke and the pinion flange.
3. CAUTION: Do not allow the output shaft to turn.
Index-mark the driveshaft yoke and the transmission tailshaft.
4. Remove the four bolts.
5. CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke from the flange.
