E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Front Door Window Regulator: Service and Repair
Removal and Replacement
Heavy Duty Riverter
Special Tool(s)
REMOVAL
1. Remove the front door window glass.
2. Remove the window regulator electric drive (if so equipped).
3. Remove the center pins from the rivets using a drift. Using a 1/4-inch diameter drill, drill out the rivets attaching the window regulator lower
bracket to the inner panel.
NOTE: Use care not to enlarge the sheet metal holes in the door inner panel.
4. Remove the two nuts retaining the window regulator upper bracket to the door inner panel.
5. Remove the window regulator.
INSTALLATION
1. Follow the removal procedure in reverse order.
-
Use the Heavy Duty Riveter D80L-23200-A or equivalent to install rivets.
