E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Brake Switch (Cruise Control): Service and Repair
Brake Pressure Switch
REMOVAL
1. Disconnect the battery ground cable. On vehicles equipped with dual batteries use proper disconnect procedures. See: Starting and
Charging/Battery/Service and Repair/Service Procedures/Dual Battery Disconnect
2. Disconnect the brake pressure switch electrical connector, then remove the brake pressure switch.
INSTALLATION
1. Follow the removal procedure in reverse order.
NOTE
-
On vehicles equipped with dual batteries use proper reconnect procedures. See: Starting and Charging/Battery/Service and Repair/Service
Procedures/Dual Battery Disconnect
-
When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module relearns its
adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
-
After the procedure is finished, perform brake bleeding procedures.
