E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
3. Connect the heater blower motor switch resistor electrical connector.
4. Connect the blower motor electrical connector.
5. Install the condenser to evaporator tube.
NOTE: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
6. Install the suction accumulator/drier.
7. Realign the battery tray support brackets.
8. Install the windshield fluid reservoir.
10. Install the windshield washer reservoir cover.
a. Install the windshield washer reservoir cover.
b. Install the screws.
11. Install the heater.
12. Fill the engine cooling system.
