E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Remove the accessory drive belt.
2. Raise and support the vehicle.
3. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
4. Remove the A/C compressor.
1
Remove the A/C compressor bolts.
2
Remove the A/C compressor and position aside.
NOTE: Do not remove lines from the A/C compressor.
5. Remove the (A) CKP sensor bolt and the (B) CKP sensor.
INSTALLATION
To install, reverse the removal procedure.
