E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Keyless Entry Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the left quarter trim panel.
3. Remove the remote keyless entry module.
1. Disconnect the two electrical connectors.
2. Remove the two nuts.
3. Remove the remote keyless entry module.
INSTALLATION
1. Follow the removal procedure in reverse order.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
