E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Clockspring Assembly / Spiral Cable: Service and Repair
REMOVAL
NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
1. Remove the driver side air bag module.
2. Remove the steering wheel.
NOTE: Make sure the wheels are in the straight-ahead position.
3. If so equipped, twist the tilt wheel handle and shank and remove.
4. Remove the lower steering column shroud.
1
Remove the three screws.
2
Remove the steering column shroud.
5. Remove the ignition switch lock cylinder.
1
Position the lock cylinder to RUN.
2
Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.