E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Seat Belt: Service and Repair
Service Procedures
Post Collision Inspection
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), if so equipped, child
safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt assemblies should be replaced unless a
qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be
inspected and replaced if either damage or improper operation is noted.
Safety belt assemblies should be periodically inspected to make sure they have not become damaged and that they remain in proper operating
condition, particularly if they have been subjected to severe stress.
Before installing the new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points are
damaged and distorted, the sheet metal must be reworked back to its original shape and structural integrity.
Install the new safety belt(s) using the appropriate instructions. Perform Functional Test Procedure in Testing and Inspection.
Safety Belt Tongue Rotated on Belt
1. Grasp the belt tongue and pull down on the closest belt webbing to form a loop through the upper (narrower and longer) slot in the tongue.
2. Working within the upper slot, rotate and fold the belt webbing over itself as required to remove the twist.
3. Pull the excess belt webbing back through the upper slot in the tongue.
4. Repeat Steps 1-3 to complete the removal of the twist at the lower (wider and larger) slot in the tongue.
