E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Starter Bearing: Testing and Inspection
1. Inspect the drive end housing bushing and the brush end plate bushing for excessive wear.
2. Replace the bushing if worn or scored.
1
The bushings can be removed using a puller of the appropriate size.
2
Immerse new bushings in engine oil (SAE 30 or 40) for at least 20 minutes before installation.
3
Press or tap the new bushing into position, using a driver.
NOTE: Do not ream the bushings after installation, since the self-lubricating qualities of the bushing could be damaged.
