E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
NOTE:
-
The direct clutch friction plates have lube grooves in the friction material.
-
Depending on model, install a 3-, 4- or 5- plate clutch pack.
8. Install the selective direct clutch pressure plate retaining ring.
9. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct selective direct clutch pressure plate retaining ring and recheck the clearance.
10. Install the No. 7 intermediate one-way clutch large thrust washer, aligning the (A) tabs with the (B) notches.
11. Install the bottom end cap.
NOTE: The top and bottom end caps are identical.
