E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
INSTALLATION
1. Place the new extension housing gasket on the extension housing.
NOTE: Lightly lubricate the gasket with petroleum jelly to hold it in place during assembly.
2. Install the (A) extension housing, the 8 (B) bolts and the (C) stud.
NOTE: Make sure the fasteners are installed in their proper locations as noted during removal.
3. Install the (A) vehicle speed sensor (VSS) and the (B) bolt. Connect the (C) harness connector.
4. Install the (A) transmission insulator and retainer and the (B) bolts.
