E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
14. Press the fluid filter and seal assembly into the pump bore until seated.
NOTE: Prior to installation, lightly lubricate the seal with clean MERCON(R) V Automatic Transmission Fluid XT-5-QM or equivalent.
15. Position the (A) gasket onto the cleaned fluid pan. Make sure the (B) magnet is positioned over the dimple in the fluid pan.
NOTE: Apply a light coat of petroleum jelly to hold the gasket to the fluid pan.
16. Install the (A) pan with gasket. Alternately tighten the 20 (B) bolts.
17. Connect the harness connector to the digital transmission range (DTR) sensor.
18. Remove the supports and lower the vehicle.
19. Connect the battery.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control
module relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
