E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
ASSEMBLY
1. Install the (A) main regulator valve assembly, the (B) converter clutch shift valve assembly, and the (C) converter regulator valve assembly.
-
Install the (A) main regulator valve assembly. Then, apply pressure to the (D) main regulator booster sleeve and install the (E) retainer, making
sure it is properly seated.
-
Install the (B) converter clutch shift valve assembly. Then, apply pressure to the (F) end plug and install the (G) retainer, making sure it is
properly seated.
-
Install the (C) converter regulator valve assembly. Then, apply pressure to the (H) end plug and install the (I) retainer, making sure it is
properly seated.
2. Install the (A) gerotor gearset, with the (B) dot facing the control body assembly.
NOTE: Prior to installation, lightly lubricate the gerotor gears with clean MERCON(R) V Automatic Transmission Fluid XT-5-QM or
equivalent.
3. Lower the (A) control body and stator assembly onto the (B) pump body, aligning the (C) 28-mm hole in each body.
CAUTION:
