E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
(1) Loosen, but do not remove, the 20 fluid pan-to-case retaining bolts.
(2) Remove the 16 front and side fluid pan-to-case retaining bolts.
(3) Lower the front of the fluid pan and allow the fluid to drain.
(4) With the fluid pan properly supported, remove the (A) fluid pan-to-case retaining bolts and the (B) fluid pan and gasket.
CAUTION: Do not discard the gasket unless damaged. This is a reusable gasket.
7. Remove the filter and seal assembly by carefully pulling and rotating the filter as necessary.
NOTE: After removal, discard the filter and seal assembly.
8. If the seal remains in the pump bore, remove it carefully with a small screwdriver so as not to scratch or damage the aluminum bore.
CAUTION: Be careful not to scratch or damage the aluminum bore.
9. Using the (A) Lock Nut Pin Remover, remove the (B) manual lever shaft retaining pin.
NOTE: A No. 53 drill bit (1/16-inch) can be used instead to remove the manual lever shaft retaining pin.
