E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Technical Service Bulletin # 00-15-4
Date: 000724
Rear Axle, Dana 80,- Whine Noise
Article No.
00-15-4
07/24/00
^
AXLE - REAR AXLE "WHINE" NOISE - VEHICLES
EQUIPPED WITH DANA 80 AXLES - 5.4L/6.8L
VEHICLES BUILT THROUGH 5/24/2000 AND 7.3L
VEHICLES BUILT THROUGH 12/18/1999
^
NOISE - REAR AXLE "WHINE" - VEHICLES
EQUIPPED WITH DANA 80 AXLES - 5.4L/6.8L
VEHICLES BUILT THROUGH 5/24/2000 AND 7.3L
VEHICLES BUILT THROUGH 12/18/1999
FORD:
1996-2000 ECONOLINE
ISSUE
Some E-450 Super Duty Cutaway/Stripped Chassis vehicles with Dana 80 rear axles may exhibit an excessive amount of axle "whine" noise.
Replacement of the axle is not always necessary. Axle whine often is corrected by replacing only the rear driveshaft of the driveshaft assembly with a
dampened rear driveshaft. The dampened rear driveshaft should always be installed before the axle is replaced.
ACTION
Install a dampened rear driveshaft and evaluate for the amount of improvement. If improvement does not meet customer expectation, then replace the
axle assembly. Refer to the following Service Procedure for details.
FIGURES OF DRIVESHAFT FLANGES