E 250 3/4 Ton Van V8-5.4L CNG VIN M (1997)
Universal Joint: Service and Repair
DISASSEMBLY
1. Place the driveshaft on a suitable workbench being careful not to damage the tube.
CAUTION: Do not clamp the driveshaft in the jaws of a vise or similar holding fixture.
2. Mark the positions of the driveshaft components.
NOTE: If components are not marked and therefore installed incorrectly, driveline imbalance can occur.
3. Clamp U-Joint Tool in a vise.
4. Remove the snap rings.
5. Remove the driveshaft slip yoke.
(1) Position the driveshaft slip yoke in U-Joint Tool.
(2) Press out a bearing cup.
