E 250 Van L6-300 4.9L (1984)
2000 feet altitude, use a 0.810 inch float level gauge instead of the 0.780 gauge specified. A 13/16 inch drill can be used as a float level gauge
above 2000 feet altitude, and a 25/32 inch drill can be used at lower altitudes. When using a drill, be careful to measure only to the identation on
the float.
5.
If the above steps do not resolve the concern, reset the idle mixture using the propane enrichment method outlined in TSB 85-1-23. However, if a
reset is necessary (Step IIE of the TSB), use a reset of 10 RPM instead of the 30 RPM specified.
PART NUMBER
PART NAME
CLASS
E4PZ-9564-A
Fuel Inlet Needle
A
OTHER APPLICABLE ARTICLES: 84-7-13
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP9564A85
TIME:
1.1 Hrs. Bronco, F-Series 1.4 Hrs. E-Series DLR. CODING: Basic Part No. 9564 - Code: 94