E 250 Van L6-300 4.9L (1984)
Spindle Pin: Service and Repair
Spindle Bushings
Spindle Bushing Tools
REMOVE
1. Remove the spindle. Refer to Spindle/Service and Repair.
2. The bronze spindle bushings have an inside diameter of 1.0552/1.0562 inch, use the following tools: Reamer D82T-3110-A, Bushing
Remover/Installer Driver, D82T-3110-B and Driver Handle D82T-3110-C or equivalents.
NOTE: Each side of the Bushing Remover/Installer Driver tool is marked with a "T" or a "B". Use the side with the "T" stamping to install the top
spindle bushing. Use the side with the "B" stamping to install the bottom spindle bushing.
3. Remove and discard the seal from the bottom of the upper bushing bore of the upper spindle yoke.
