E 250 Van V8-7.3L DSL (1988)
FIGURE 7
4.
Cut out the template, Figure 7.
FIGURE 8
5.
Position the template on the plastic case as shown in Figure 8.
6.
Scribe the plastic case to correctly locate the resistor opening and two (2) mounting screw holes.
7.
Cut the resistor opening with a hot knife or a saw. Using a 5/32" drill bit, drill the two (2) new mounting screw holes.
8.
Install the two (2) resistor mounting clips removed in Step 3 over the new mounting screw holes.
9.
Position the new blower motor resistor, (E8UZ- 19A706-A) with the windings facing upward.
FIGURE 9
