E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Braking Sensor/Switch: Service and Repair
REMOVAL
1. Disconnect wiring harness connector from stoplight switch.
2. Remove self-locking pin and spacer from brake pedal pin.
3. Slide brake booster rod and stoplight switch off brake pedal pin.
4. Remove stoplight switch and bushing from brake booster rod.
INSTALLATION
1. Position bushing in stoplight switch.
2. Position stoplight switch on brake booster rod, aligning holes.
3. Slide brake booster rod and stoplight switch onto brake pedal pin.
4. Install spacer and self-locking pin on brake pedal pin.