E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Retainer
7
2A635
Parking Brake Rear Cable and Conduit
8
57632-S2
Screw and Washer, Parking Brake Rear
Cable and Conduit Clip
9
N804729-S100
Clip
10
2A709
Rear Parking Brake Cable Retainer
11
2A635
Parking Brake Rear Cable and Conduit
12
N620481-S2
Nut, Parking Brake Control-to
-Steering Column Support
A
--
Tighten to 17-23 N-m
(13-16 Lb-Ft)
B
--
Tighten to 17-23 N-m
(13-16 Lb-Ft)
Rear
REMOVAL
1. Relieve tension on the system by having an assistant pull directly rearward on the intermediate or front parking brake cable and conduit, using care
not to damage the coating on the parking brake cable strand, insert a 4mm (0.156 in) or equivalent into the hole provided in the parking brake
control.
2. Raise the vehicle and remove the LH or RH as necessary, hub cap, wheel, and brake drum.
3. Disconnect the LH or RH as necessary, parking brake rear cable and conduit from the parking brake cable equalizer.
4. Compress the prongs that retain the parking brake rear cable and conduit shield to the parking brake cable bracket by using a 1/2-inch 12-point
box end wrench.
5. With the spring tension released, lift the parking brake rear cable and conduit out of the slot in the parking brake lever.
6. Working on the wheel side, compress the prongs on the cable retainer so they can pass through the hole in the brake backing plate. Draw the rear
parking brake cable retainer and the parking brake rear cable and conduit out of the hole.
INSTALLATION
1. Push the parking brake rear cable and conduit and the rear parking brake cable retainer through the brake backing plate and through the routing
clip (if present) until the end of the parking brake rear cable and conduit can be inserted through the slot in the parking brake lever.
2. Insert the front end of the brake master cylinder push rod bushing through the parking brake cable bracket until the prongs expand.
3. Install the brake drum, wheel, and hub cap, and adjust the rear brakes.
4. Remove the pin inserted in the parking brake control to take up cable slack.
5. Operate the parking brake control three times to verify the parking brake system is functioning properly.