E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Vacuum Pump: Service and Repair
REMOVAL
1. Remove air cleaner.
2. Remove drive belt (8620).
3. Partially drain engine coolant.
4. Remove upper radiator hose clamps and upper radiator hose (8260).
5. Disconnect coolant reservoir hose at radiator and support.
6. Remove fan blade (8600) and fan clutch (8A616) using Fan Clutch Nut Wrench T83T-6312-B and Fan Clutch Pulley Holder T94T-6312-AH, set
fan blade and fan clutch in fan shroud (8146).
Fan Clutch Removal
7. Remove two fan shroud screws.
8. Remove fan shroud and fan blade and fan clutch.
9. Remove vacuum pump pulley using Steering Pump Pulley Remover T69L-10300-B.
10. Remove vacuum pump bolts.
11. Disconnect vacuum pump hose and remove vacuum pump (2A451).
INSTALLATION
1. Connect vacuum pump hoses and install vacuum pump.
2. Install vacuum pump bolts. Tighten bolts to 24-31 N-m (18-23 lb-ft).
3. Install vacuum pump pulley using Steering Pump Pulley Replacer T65P-3A733-C.
4. Position the fan shroud, fan blade and fan clutch.
5. Install fan shroud screws.
6. Install fan blade and fan clutch using Fan Clutch Nut Wrench T83T-6312-B and Fan Clutch Pulley Holder T94T-6312-AH.
7. Connect coolant reservoir hose at radiator and support.
8. Install upper radiator hose and hose clamps.
9. Refill engine coolant.
10. Install drive belt.
11. Install air cleaner assembly.