E 250 Van V8-7.3L DSL Turbo VIN F (1995)
8.
Install a revised IDM (F7TZ-12B599-AC) with foam installed on the IDM as shown in Figure 1. Be certain to protect the breather vent.
9.
Install the IDM back into the vehicle being careful not to disturb the foam.
10.
Reinstall the IDM mounting bolt and torque the bolt to 9-11 Nm (77-99 lb-in).
11.
Install the IDM connector and torque the bolt to 5-7 Nm (47-63 lb-in).
12.
Reinstall the Q bottle and reconnect the batteries.
13.
Perform an injector "buzz" test using NGS to verify the repair is complete.
PARTS BLOCK
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 96-19-9
WARRANTY STATUS: INFORMATION ONLY
Disclaimer