E 250 Van V8-7.3L DSL Turbo VIN F (1995)
8. Remove the high pressure oil pump reservoir retaining nut and bolts and position wiring harness aside.
9. Remove the reservoir and disconnect the wire connectors from the sensors at the top and back of the reservoir.
10. Remove the high pressure oil pump drive gear.
11. Inspect gear for damage. Service as required.
12. Clean mating surfaces of crankcase front cover, cover plate, and reservoir.
INSTALLATION
1. Install the high pressure oil pump drive sprocket into the crankcase front cover.
2. Install the high pressure oil pump.
3. Install the oil pump drive sprocket, bolt, and washer. Tighten bolt to 129 Nm (95 ft lb).
NOTE: Make sure the oil pump drive sprocket is fully seated on the shaft of the oil pump before installing the bolt and washer or sprocket may
not seat properly. The end of high pressure oil pump shaft should be flush with the front face of the oil pump drive sprocket.
4. Check oil pump drive sprocket backlash as follows:
