E 250 Van V8-7.3L DSL Turbo VIN F (1995)
1.
Locate ignition control module under hood. On F-Series models, it is located on the left inner fender panel near the hood hinge. See Figure 1. On
E-Series models, it is located behind the battery on the dash panel. See Figure 2.
2.
On Econoline models only, disconnect and position battery out of the way.
3.
Remove two screws retaining ignition control module heat-sink assembly to left fender apron.
4.
Disconnect harness connector from ignition control module.
5.
Inspect date code on module. If the date code is 4L18B, the module must be replaced. See Figure 3 for date code location. Continue on to next
step. If not, go to step 9.