E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Second Row RH Belt Stowage (Typical)
Removal
1. Disengage the rear safety belt retractor and tongue from seat by inserting key or small screwdriver into slot located in detachable anchor.
NOTE:
-
Prior to vehicle delivery, customers must be shown the locations of the detachable anchors, their usage and the proper use of the rear seat shoulder
strap hook.
-
Safety belt must be detached when removing rear seat. Rear seat shoulder safety belts should remain engaged in the detachable anchors, except
when the rear seats require removal.
WARNING: WHEN INSTALLING A REAR SEAT IN THE VEHICLE, INSTALL THE REAR SEAT IN ITS ORIGINAL LOCATION.
IMPROPER INSTALLATION OF THE SEAT WILL PREVENT CORRECT USE OF THE SHOULDER SAFETY BELTS.
IMPROPER USE OF THE SAFETY BELTS COULD INCREASE THE RISK AND/OR SEVERITY OF INJURY AND ACCIDENTS.
2. Lift screwdriver up and disengage belt.
3. Whenever a rear seat has been removed, the tongue end, of the detachable anchor, should be correctly stowed. Refer to illustrations provided.
Installation
1. Insert detachable anchor tongue into detachable anchor until a snap is heard and the latch is felt to be engaged.
-
Rear safety belt retractor and tongue should not be twisted. If it is twisted, disengage tongue end and straighten twist. Reinsert tongue.
Front Safety Belt
