E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Safety Belts, Front Outboard Position, Bucket and Captain's Chairs - Cutaway Only
Removal
1. If removing the driver side safety belt buckle end, disconnect the battery ground cable.
2. If removing the driver side buckle end, disconnect the buckle end electrical connector.
3. Remove the buckle end anchor bolt.
4. Remove the safety belt buckle end from the vehicle.
Installation
To install, reverse the removal procedure. Seal the anchor bolt hole with Ford Caulking Cord D6AZ-19560-A. Tighten the anchor bolt to 30-40 Nm
(22-29 lb-ft). Check the restraint system for proper operation.