E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Impact Sensor: Service and Repair
Right Rear (Frame) Primary Crash Sensor and Bracket
Removal
1. Disconnect battery positive cable and wait one minute for backup power supply energy to be depleted.
WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE
BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY,
THE BATTERY POSITIVE CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM
COMPONENTS.
NOTE:
-
To service stripped frame air bag sensor and bracket retaining screws, replace screws with 13 mm screw. Tighten to 13-17 Nm (10-13 lb-ft).
-
When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM)
relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
2. Disconnect sensor wiring connector from wiring assembly connector.
3. Remove two screws retaining primary sensor to the RH frame rail.
Installation
1. Position sensor to RH frame rail.
2. Secure sensor with two screws. Tighten screws to 13-17 Nm (10-13 lb-ft).
3. Connect sensor wiring connector to wiring assembly connector and secure with retainer.
4. Connect battery positive cable.
5. Verify air bag indicator.
