E 250 Van V8-7.3L DSL Turbo VIN F (1995)
Clutch: Service and Repair
Forward Clutch
Forward Carrier
REMOVAL
1. Remove needle bearing assembly from carrier.
2. Remove thrust washer from front side of carrier.
INSTALLATION
1. Reverse procedure to install, noting the following:
a. Thrust washer tabs go into carrier.
b. Install notched inner race facing outward.
Forward Hub and Ring Gear
REMOVAL
1. Remove plastic thrust washer No. 7D090 from front face of hub.
2. Remove snap ring, then the forward hub from ring gear.
INSTALLATION
1. Reverse procedure to install.
With C6
DISASSEMBLE
CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean
automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with
petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.
Forward Clutch Pressure Plate Snap Ring Removal
1. Remove pressure plate snap ring.
