E 350 V10-6.8L (2007)
2. Remove the front door inner beltline weatherstrip.
3. Remove the rear glass channel bolt and lift the channel.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Lower the window glass to gain access to the 2 glass bracket retaining rivets.
5. CAUTION: Do not attempt to pry out the rivets, as damage to the front door window glass can result. Prior to removing the rivet center
pins, it is recommended that a suitable block support be placed between the front door outer panel and the glass bracket to stabilize the
glass during rivet removal.
Remove the center pins from the rivets, using a drift. Using a 1/4-inch diameter drill, drill out the remainder of the rivets.
6. Lift up and rotate the front door window glass clockwise and remove.
