E 350 V10-6.8L (2007)
11. Remove the front safety belt guide.
1. Remove the nut.
-
To install, tighten to 48 Nm (35 lb-ft).
2. Remove the front safety belt guide.
12. Remove the front upper body side trim panel.
1. Remove the 6 screws.
2. Remove the front upper trim panel from the body side.
13. Remove the front lower body side trim panel.
1. Remove the screw.
2. Remove the 2 pin-type retainers.
3. Lift the front upper trim panel slightly upward and remove from the body side.
14. NOTE:
-
To install the front upper body side trim panel, start at the lower pillar, then work to the second lower pillar.
-
To install the rear lower body side trim panel, start with the clip to the heater housing, then snap the trim panel into the panel clips.
-
To install the rear upper body side trim panel, start with the rear lower portion of the panel at the pillar.
To install, reverse the removal procedure.
