E 350 V10-6.8L (2007)
Door Lock Cylinder: Service and Repair
DOOR LOCK CYLINDER
Removal and Installation
All doors
NOTE:
-
When a new lock cylinder is installed, the door lock cylinder and ignition lock cylinder should be installed as a set. This eliminates carrying an
extra key which fits only one lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.
-
Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock
repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
1. If equipped, remove the door trim panel.
Side Door/Front Door
2. Disconnect the lock cylinder actuating rod.
3. Remove the retainer and the door lock cylinder.
Rear Door
4. Remove the 4 license plate housing screws.
5. Position the housing away from the door.