E 350 V10-6.8L (2007)
2. Rotate the cushion inboard side shield upward to release the rear pushpin mount from the slot.
3. Hold the cushion inboard side shield in one hand and release the retaining clips holding the safety belt buckle and pretensioner boot to the
cushion inboard side shield.
4. Remove the cushion inboard side shield.
7. Remove the pin-type retainer from the upper seat track mounting flange and install it back into the cushion inboard side shield.
Seats without a cushion inboard side shield
8. At the rear inboard of the cushion trim cover, release the hook-and-loop strips, separate the J-clips and remove the pin-type retainer.
Seats with lumbar
9. Remove the lumbar actuator.
1. Remove the 2 screws.
2. Disconnect the cable from the lumbar actuator.
Route out the lumbar cable from under the seat.
All seats
10. Remove the side shield screw from behind the recliner handle.
