E 350 V10-6.8L (2007)
Seat Cushion: Overhaul
Seat Cushion - Front
Seat Cushion - Front
Disassembly
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow
this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of
serious personal injury or death.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in
serious personal injury or death.
NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the seat. For additional information, refer to Seat Front in this section.
2. Remove the seat backrest. For additional information, refer to Seat Backrest Front in this section.
3. Remove the seat cushion. For additional information, refer to Seat Cushion Front in this section.
4. NOTE: Note the wiring harness pin-type retainer locations for assembly.
Remove the power seat wiring assembly from the seat cushion.
5. Remove the cushion trim cover.
1. Release all cushion trim cover J-clips.
2. Remove the cushion frame from the cushion foam pad and cushion trim cover.
3. Separate the hook-and-loop strips and remove the cushion trim cover.
6. To assemble, reverse the disassembly procedure.
Seat Cushion - Second Row, Bucket
SEAT CUSHION - SECOND ROW, BUCKET
