E 350 V10-6.8L (2007)
Seat Heater Switch: Service and Repair
SEAT CONTROL SWITCH
Removal and Installation
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing
so could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the supplemental restraint system (SRS). See: Restraint Systems/Air Bag Systems/Service and Repair
2. Remove the screw from behind the manual backrest adjust handle.
3. Remove the cushion side shield front screw.