E 350 V10-6.8L (2007)
Removal and Installation
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately
wash it with water.
All vehicles
1. Disconnect the battery ground cable. For additional information, refer to Battery.
Vehicles with 6.0L engines
2. Remove the turbocharger inlet tube. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the air cleaner assembly. For additional information, refer to Fuel Delivery and Air Induction.
Vehicles with 4.6L and 5.4L engines
4. Remove the 3 bolts and position the degas bottle aside.
^
To install, tighten to 10 Nm (89 inch lbs).
5. Detach the power steering fluid reservoir and position the reservoir aside.
All vehicles
6. NOTE: Plug each port of the hydraulic control unit (HCU) to prevent brake fluid from spilling.
Disconnect the 3 brake tube fittings from the HCU.
^
To install, tighten to 20 Nm (15 ft. lbs).