E 350 V10-6.8L (2007)
2. NOTE: Use new copper washers on the brake caliper flow bolt.
Remove the brake caliper flow bolt and position the brake hose aside.
^
Discard the copper washers.
^
To install, tighten to 35 Nm (26 ft. lbs).
3. CAUTION: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
Remove the 2 brake caliper pin bolts and the brake caliper.
^
To install, tighten to 36 Nm (27 ft. lbs).
4. To install, reverse the removal procedure.
^
Bleed the brake caliper.