E 350 V10-6.8L (2007)
All vehicles
1. Disconnect the battery. For additional information, refer to Battery.
2. Use a suitable suction device to remove the brake fluid from the brake master cylinder reservoir.
3. Remove the coolant reservoir bolts and position the reservoir aside.
^
To install, tighten to 10 Nm (89 inch lbs).
Diesel engine equipped vehicles
4. Disconnect the coolant hoses from the air cleaner outlet tube.
5. Loosen the clamp and disconnect the air cleaner outlet tube.
^
To install, tighten to 4 Nm (35 inch lbs).
6. Disconnect the mass air flow (MAF) sensor electrical connector.
7. Disconnect the 3 latches and remove the air cleaner cover.
Gasoline engines equipped vehicles
8. Disconnect the power cable at the power distribution box and position the box aside.
All vehicles
9. Disconnect the brake fluid level switch electrical connector.
10. Disconnect the speed control deactivator switch electrical connector.
11. Disconnect the master cylinder brake tubes.
^
To install, tighten to 18 Nm (13 ft. lbs).
^
For vehicles equipped with traction control and stability assist, tighten to 28 Nm (21 ft. lbs).
12. Remove the nuts and the power steering tube clamp.
^
To install, tighten to 9 Nm (80 inch lbs).
