E 350 V10-6.8L (2007)
Radiator: Service and Repair
Radiator - 4.6L, 5.4L and 6.8L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the cooling fan.
3. If equipped, remove the underbody splash shield.
4. NOTE: Typical shown, others similar.
Disconnect the transmission oil cooler hoses.
^
Plug or cap the lines as needed.
5. Disconnect the lower radiator hose.
6. Remove the 4 bolts and the 2 radiator support brackets.
^
To install, tighten to 20 Nm (15 ft. lbs).
7. Remove the radiator from the vehicle.
8. To install, reverse the removal procedure.
^
If necessary, install new appropriately sized worm drive-type clamps.
