E 350 V10-6.8L (2007)
4. Using a new crankshaft pulley bolt, install the crankshaft pulley bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the
bolt in 4 stages:
^
Stage 1: Tighten to 90 Nm (66 ft. lbs).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs).
^
Stage 4: Tighten an additional 90 degrees without exceeding 200 Nm (148 ft. lbs).
5. Rotate the tensioner clockwise and install the accessory drive belt onto the crankshaft pulley.
6. Install the engine cooling fan and the fan shroud.