E 350 V10-6.8L (2007)
3. Connect the EOP switch electrical connector.
Both engine support insulators
4. Lower the engine and remove the special tools.
5. Install the 4 engine support insulator-to-crossmember nuts.
^
Tighten to 90 Nm (66 ft. lbs).
6. NOTE: Do not reuse the O-ring seal.
Install a new O-ring seal and the heater outlet tube.
^
Lubricate the O-ring seal with clean engine coolant prior to installation.
7. Hand-tighten the heater outlet tube upper stud and install the lower stud.
^
Tighten to 40 Nm (30 ft. lbs).