E 350 V10-6.8L (2007)
6. Tighten the bolts in 3 stages, in the sequence shown.
^
Stage 1: Tighten to 2 Nm (18 inch lbs).
^
Stage 2: Tighten to 20 Nm (15 ft. lbs).
^
Stage 3: Tighten an additional 60 degrees.
7. Lower the engine and remove the special tools.
8. Position the flywheel inspection plate and install the 2 bolts.
^
Tighten to 34 Nm (25 ft. lbs).
9. Install the engine support insulator nuts.
^
Tighten to 90 Nm (66 ft. lbs).
10. Position the transmission fluid cooler tube support bracket and install the nut.
^
Tighten to 30 Nm (22 ft. lbs).