E 350 V10-6.8L (2007)
5. Using a new O-ring seal, position the CKP sensor and install the bolt.
^
Tighten to 10 Nm (89 inch lbs).
6. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
7. Using the special tools, install a new crankshaft front seal.
8. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket
remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is
longer. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
