E 350 V10-6.8L (2007)
Evaporator Case: Service and Repair
EVAPORATOR CORE HOUSING
Removal and Installation
1. Remove the heater core housing.
2. Remove the evaporator core.
3. Detach the wire harness.
1
Remove the nut and stud.
2
Disconnect the electrical connector and position the wire harness aside.
4. Remove the bolts and the suction accumulator.
-
To install, tighten to 14 Nm (10 lb-ft).
5. Remove the washer reservoir.
1
Remove the nut.
2
Remove the bolt.
3
Remove the washer reservoir.
-
Disconnect the washer hose and washer pump electrical connector.