E 350 V10-6.8L (2007)
6. Disconnect the auxiliary evaporator inlet line fitting.
-
Discard the O-ring seals.
All vehicles
7. Remove the evaporator inlet fitting bracket screw.
-
To install, tighten to 2 Nm (18 lb-in).
8. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
Disconnect the evaporator inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 18 Nm (13 lb-ft).
9. Remove the condenser-to-evaporator line.
10. To install, reverse the removal procedure.
-
Install a new gasket seal (if equipped) and new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test and charge the A/C system.
