E 350 V10-6.8L (2007)
3. Loosen the RH rear bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the
RH rear bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the rear bleeder screw and disconnect the waste hose.
^
Tighten to 15 Nm (11 ft. lbs).
5. Repeat Steps 2, 3 and 4 for the LH rear bleeder screw, the RH front disc brake caliper bleeder screw and the LH front disc brake caliper bleeder
screw, in that order.
6. Connect the scan tool to the data link connector (DLC) and follow the scan tool instructions.
7. Repeat the system bleed procedure as described in Steps 1 through 5.
Caliper
1. NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper was disconnected.
Place a box end wrench on the disc brake caliper bleeder screw. Attach a rubber drain hose to the disc brake caliper bleeder screw, and submerge
the free end of the hose in a container partially filled with clean, specified brake fluid.
2. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
3. Loosen the disc brake caliper bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal,
tighten the disc brake caliper bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the front and rear bleeder screw.
^
Tighten to 15 Nm (11 ft. lbs).
