E 350 V10-6.8L (2007)
Midship Fuel Tank (Part 2)
Exploded View
Removal and Installation
WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still
presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel is present in the area. Failure to follow these instructions may result in
personal injury.
NOTE: Midship fuel tank evaporative emission (EVAP) canister shown, aft-of-axle fuel tank EVAP canister similar.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the spare tire.
4. Disconnect the EVAP hose and tube quick connect coupling.
5. Disconnect the EVAP canister vent solenoid electrical connector and harness retainer.
Van/wagon vehicles
6. Remove the heat shield bolt.
-
To install, tighten to 18 Nm (13 lb-ft).
7. Remove the lower EVAP canister and bracket assembly bolts and the heat shield.
-
To install, tighten to 18 Nm (13 lb-ft).
All vehicles
8. NOTE: Van/wagon vehicle lower EVAP canister and bracket assembly bolts will already be removed.
Remove the EVAP canister and bracket assembly bolts and remove the EVAP canister and bracket assembly from the vehicle.
-
To install, tighten to 18 Nm (13 lb-ft).
