E 350 V10-6.8L (2007)
2. Remove the bolt and the safety belt shoulder guide.
-
To install, tighten to 40 Nm (30 lb-ft).
3. If equipped, release the detachable safety belt anchor from the seat.
4. Detach the body side trim finish panel.
1
Remove the pin-type retainers.
2
Detach the finish panel from the body side.
5. If equipped, remove the bolt and safety belt retractor anchor from the floor.
-
To install, tighten to 40 Nm (30 lb-ft).
6. Remove the rear safety belt shoulder strap opening covers.
7. Detach the secondary safety belt shoulder guide.
8. Remove the bolt and the safety belt retractor.
-
Route the safety belt webbing.
-
To install, tighten to 40 Nm (30 lb-ft).
Passenger side second, third, fourth and fifth (if equipped) row retractors
9. NOTE: Inspect the safety belt shoulder guide cover for damage. If the cover is damaged install a new cover.
Open or position aside the safety belt shoulder guide cover.
10. Remove the bolt and the safety belt shoulder guide.
-
To install, tighten to 40 Nm (30 lb-ft).
11. Remove the quarter trim upper panel, the quarter trim lower panel, the quarter trim rear upper panel and the body side trim cover panel.
12. Detach the safety belt retractor anchor.
-
If equipped, release the detachable safety belt anchor from the seat.
-
If equipped, remove the bolt and safety belt retractor anchor from the floor.
-
To install, tighten to 40 Nm (30 lb-ft).
13. Detach the secondary safety belt guide (if equipped).
14. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
Driver side third, fourth and fifth (if equipped) row retractors
15. Position the safety belt shoulder guide cover aside and remove the safety belt guide bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
