E 350 V10-6.8L (2007)
4. Loosen the 3 remaining battery tray bolts.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Slide the battery tray up and to the right to disengage the battery tray from the 3 battery tray bolts and lower it onto the safety straps.
6. Remove the 2 nuts and bolts and position the battery tray cover aside.
-
To install, tighten to 7 Nm (62 lb-in).
7. Loosen the nuts and disconnect the battery terminals.
-
To connect, tighten to 15 Nm (11 lb-ft).
8. Remove the bolt and position the frame-mounted battery harness-to-frame retainer aside.
-
To install, tighten to 14 Nm (10 lb-ft).
9. Remove the 8 harness locators from the frame rail.
10. Remove the starter solenoid terminal cover.
11. Remove the nut and position the starter solenoid positive cable aside.
-
To install, tighten to 12 Nm (9 lb-ft).
12. Remove the nut and position the starter solenoid wire terminal aside.
-
To install, tighten to 5 Nm (44 lb-in).
13. Remove the nut and position the battery ground cable terminal aside.
-
To install, tighten to 23 Nm (17 lb-ft).
14. Remove the nut and position the battery cable lower bracket aside.
-
To install, tighten to 15 Nm (11 lb-ft) (4.6L) or 55 Nm (41 lb-ft) (5.4L, 6.8L).
15. Separate the transmission cooler line clip from the battery cable lower bracket.
16. Remove the harness locator from the frame.
17. Remove the nut and position the battery ground cable eyelet aside.
-
To install, tighten to 8 Nm (71 lb-in).
18. Remove the nut and position the generator cable and BJB terminals aside.
-
To install, tighten to 9 Nm (80 lb-in).
19. Remove the battery cable assembly.
20. To install, reverse the removal procedure.
