E 350 V10-6.8L (2007)
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of
the power steering components may result.
NOTE: The hydraulic booster jumper line and the power steering pressure line can be serviced separately. It is not necessary to disconnect the
jumper line from the hydraulic booster when servicing the power steering pressure line
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Using a suitable suction device, drain the power steering fluid reservoir.
6.0L Diesel vehicles
3. Remove the pushpin retainers and the upper air deflector.
4. Remove the 2 power steering fluid reservoir bracket-to-cowl bolts.
^
To install, tighten to 14 Nm (10 ft. lbs.)
5. Remove the 2 power steering fluid reservoir bracket-to-radiator support bolts.
